| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (111/202) > >> |
| Benedikt:
--- Quote from: jjae6 on May 03, 2017, 02:40:52 AM --- --- Quote from: riorao on May 02, 2017, 02:21:17 PM ---Hello! I use two motors on the X axis. This controller will work with this configuration? there is synchronization? --- End quote --- I think I have read in this post that some people use 2 motors on one axis, but with two drivers, one per motor. --- End quote --- So did I, but I had to invert the actual motor signals to one of the steppers. Then it worked well. |
| old Zozo:
Hi All, After a long time I'd like use my controller again. I thought I save my setup, but I can't find userVar file. Linuxrc runs on my controller, -which file does include my setup? (Or is not a good choice for linuxrc?) Root has only mnt DIR, and linuxrc file, mnt has nand1-1 DIR, what includes some file, as: chs eng motion.out setting ...and some .nc files Thanks. I just see that Benedikt worked a lot for us again, thank you so much for it. |
| Benedikt:
--- Quote from: old Zozo on May 03, 2017, 10:20:25 AM ---Hi All, After a long time I'd like use my controller again. I thought I save my setup, but I can't find userVar file. Linuxrc runs on my controller, -which file does include my setup? (Or is not a good choice for linuxrc?) Root has only mnt DIR, and linuxrc file, mnt has nand1-1 DIR, what includes some file, as: chs eng motion.out setting ...and some .nc files Thanks. I just see that Benedikt worked a lot for us again, thank you so much for it. --- End quote --- Thanks! Unfortunately it is not possible to recover the userVar.set (yet) from the controller itself. The data is getting binary encoded IIRC and put into the settings file. You can copy the file /mnt/nand1-1/settings to /udisk-sda1 if you want to back it up, but you cannot edit it externally. Regards, Benedikt |
| old Zozo:
So I understand, thank you very much. |
| old Zozo:
One more question, Is it possible to restore the factory windows op system? I can't find it... :scratch: |
| Navigation |
| Message Index |
| Next page |
| Previous page |