| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (103/202) > >> |
| ugv:
pour ceux qui veulent utiliser les cycles existants dans ddcsv voici des programmes les macro sont slib (contour ext circulaire) G90 G54 M03 S6000 G0 X0 Y0 Z20 G112 I30 R5 Z-1 F1000 M30 (poche carre) G90 G54 M03 S6000 G0 X0 Y0 Z20 G110 X50 Y60 R5 Z-1 F1000 M30 (poche circulaire) G90 G54 M03 S6000 G0 X0 Y0 Z20 G111 I30 R5 Z-1 F1000 M30 I=rayon R=rayon fraise X=largeur poche Y=longueur poche |
| librarymark:
Does anyone know what the current draw of this unit is? The manual that I saw says, "...the current capacity is required not to be lower than 0.5A". Not to be lower? What's up with that? I want to know what the "not to be higher" number would be. |
| Benedikt:
--- Quote from: librarymark on March 31, 2017, 05:09:57 PM ---Does anyone know what the current draw of this unit is? The manual that I saw says, "...the current capacity is required not to be lower than 0.5A". Not to be lower? What's up with that? I want to know what the "not to be higher" number would be. --- End quote --- Unfortunately, I could only measure it in idle right now, as my controller is currently not connected, but I assume this is another instance of bad English and what they actually meant was, that the maximum power consumption is 0.5A (it[the supply, I assume] shall not be lower than 0.5A). Sitting idle at 24v (with no USB connected) it draws about 110-ish mA. |
| librarymark:
Thanks, Benedikt! I suspected as much, but I could not be sure. I have ordered one of these, but it has not arrived yet. |
| BrokenEye:
That caught me out at first, I use a constant current bench PSU and I set it for 500mA , and only the buzzer sounded, I thought It was busted at first, but there was no "magic smoke" so I cranked it up to an Amp and found that it worked :) :zap: |
| Navigation |
| Message Index |
| Next page |
| Previous page |