| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (101/202) > >> |
| AVK74:
Greetings! Will the softlimits function work normally? This function does not work at this time. The axes do not stop at the base points. There is a run up to 5-10mm. That is, softlimit does not work. |
| Benedikt:
--- Quote from: AVK74 on March 18, 2017, 12:14:43 AM ---Greetings! Will the softlimits function work normally? This function does not work at this time. The axes do not stop at the base points. There is a run up to 5-10mm. That is, softlimit does not work. --- End quote --- Sorry, there is not much I can do (just yet?). Just be a little more conservative with the limits for now. |
| AVK74:
It would be great if you took note of this problem. The controller is very good, but without softlimit it is very inconvenient for me to work. |
| Joules:
The soft limits do work, but as you have noted they don't have deceleration ramp as they are approached. The solution is to set them with a tolerance. How many times do you need to use the full capacity of the machine bed. Keep tight control of your work, you shouldn't be running into the soft limits anyway. Walk the machine head round the part to make sure it fits if it's going to be that close. |
| AVK74:
--- Quote from: Joules on March 18, 2017, 08:53:36 AM ---The solution is to set them with a tolerance. --- End quote --- Unfortunately this is not a solution, but a crutch. In Mach3, this function works perfectly correctly. Only the absence of this function stops me from moving to this panel. Is no one using softlimit? It's so convenient. |
| Navigation |
| Message Index |
| Next page |
| Previous page |