| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (88/202) > >> |
| antonio:
Bendikt probably becouse my controller is 4 axis insteed 3? or probably becouse my firmware was the last version and the flash is different? sorry for my suppositions if so stupids.... |
| Benedikt:
--- Quote from: antonio on March 03, 2017, 07:50:10 PM ---Bendikt probably becouse my controller is 4 axis insteed 3? or probably becouse my firmware was the last version and the flash is different? sorry for my suppositions if so stupids.... --- End quote --- Uh, kill me. :bang: I gave you wrong instructions. It took me about 40 minutes to figure this out. You are supposed to go into the File tab and select the userVar.set entry and press Enter. That's it...... Tried it with your file and it works flawlessly... |
| antonio:
Yeah!! Now is ok... sorry but i was sure that file had been heat hiselfs... without press enter... i'm stupid. Have a good night Benedikt many thanks and tomorrow i will study for the homing sequency Inviato dal mio iPhone utilizzando Tapatalk |
| BrokenEye:
I would be very interesting to compare the firmware of a 4 axis controller to that of the 3 axis version |
| antonio:
Hi brokeneye.. can i do something for you? But note i ve already replace my original firmware with this of Benedikt. Inviato dal mio iPhone utilizzando Tapatalk |
| Navigation |
| Message Index |
| Next page |
| Previous page |