| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (86/202) > >> |
| Benedikt:
--- Quote from: antonio on March 03, 2017, 06:21:55 PM ---Many thanks for your kind reply. I was sure about the bug and for this reason already changed the extension but no difference too... I don't know way :doh: --- End quote --- Would you mind performing the upgrade? This will assure that you are running the latest version and makes me able to assist you better since I can play the scenario through on my machine. The upgrade is easily done in about 5 minutes. You extract the following archive's contents to a FAT formatted USB stick and turn off the controller. Then you plug the USB in and turn the power on. The controller will then upgrade your firmware and will reboot a few times. When it shows the home screen again, you can remove the USB. The upgrade can be downloaded from here: https://bmuessig.eu/secure/data/CNC/DDCSV11/install-mod-20161119.zip Kind regards, Benedikt |
| antonio:
Yes benedikt I'm doing right now... I'm sorry but I don't have any experiance with linux so I don't understand nothing about firmware flash etc etc... Due to I used my controller with two differente cnc machine I wonder to be able to implemet two different homing functions but I don't know how i can do... |
| antonio:
This is my job... the front panel Inviato dal mio iPhone utilizzando Tapatalk |
| antonio:
Hey Benedikt new firmware installed. Now switch off, inserted the usb memory (new formatted with fat) with uservar.set and switch on the contoller.. no change in the setting.. I have to replace one by one manually... |
| Benedikt:
--- Quote from: antonio on March 03, 2017, 06:50:31 PM ---Hey Benedikt new firmware installed. Now switch off, inserted the usb memory (new formatted with fat) with uservar.set and switch on the contoller.. no change in the setting.. I have to replace one by one manually... --- End quote --- The update was successful? Does it show PLUS in the bottom right on the main screen? Also, to apply the userVar.set (make sure the Var has a capital V), you need to toggle the power with stick inserted. Similar to the upgrade. If this still does not work. I will have a look tomorrow if you don't mind. Also it would help me if you could provide me your userVar.set file. Btw, your panel looks amazing :thumbup: |
| Navigation |
| Message Index |
| Next page |
| Previous page |