DDCSV1.1 4 Axis controller

The Shop > CNC

<< < (71/202) > >>

Will_D:
Andrew, I also remember paper tape ! Punched cards were much better as you could put the chats in to correct typos.
Just don't drop them

Problem was when the chat fell out the card reader stopped.

Some days we used to load up a file of data from 10,000 or so cards!!

Will_D:
Based on the great work done by others, attatched is a spread sheet of the parameters used by the controller, with my values and the defaults as best as I can find out

It will need renaming!

awemawson:
So is the M30 perhaps (rather oddly) cancelling any of the supposedly modal G17 G21 G90 G40 G49 G80 :scratch:

philf:

--- Quote from: awemawson on February 02, 2017, 11:39:02 AM ---So is the M30 perhaps (rather oddly) cancelling any of the supposedly modal G17 G21 G90 G40 G49 G80 :scratch:

--- End quote ---

Andrew,

Do modal commands carry over from one piece of code to a newly loaded piece of code?

Will,

I mostly use Vectric Cut2d to generate GCode and an initialising string of commands begins every file. Mach3, which I use on my mill, also adds it's own string most of which duplicate those from Cut2d.

It's not a big deal to include an initialisation string and feed rate to every file if it makes your controller work OK. I don't know if Estlcam can do this automatically.

Phil.

DaveS:
Will,

I know nothing about your controller but wearing my very faded Fanuc hat, is it possible you can insert a short dwell time between each linear move?
It may help to narrow things down. Just a thought

Dave

Navigation

 Message Index

Go to full version