| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (68/202) > >> |
| philf:
Will, For everyone's sake just type F100 into your gcode file, try it, and report back. Phil |
| Will_D:
Will do, but for the sake of info. all the original files I ran had F and S settings and a lot of other stuff that people suggested I delete. Done so, now its just moving in X and Y with default G00 & G01 speeds. See above post. I will try to video the thing tomorrow, the motors run in X and Y (thats all I have) and then after a few lines (and movement) the controller stops! I have to do a reset, and then restart from a line number then it may move a biot more. Please read my posts carefully! Can someone send me a working DDCNC g-code file so I can test this on my setup. Maybe its a parameter setting or the controller is duff! |
| Will_D:
Quick test: added F100 Same behavior ( as I would expect from post #332) It runs, it moves and the it stops. Video tomorrow |
| philf:
--- Quote from: Will_D on January 26, 2017, 05:21:01 PM ---Quick test: added F100 Same behavior ( as I would expect from post #332) It runs, it moves and the it stops. Video tomorrow --- End quote --- Will, In which case try changing the "Ignore Gcode Speeds" parameter so that it doesn't ignore them. Leave the F100 in. From what you say about some parameters not working maybe the "Ignore Gcode Speeds" parameter does work and the G01 preset speed doesn't. Phil. |
| Will_D:
Thanks Phil, yes thought of this in the wee small hours ! Will try later! |
| Navigation |
| Message Index |
| Next page |
| Previous page |