| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (52/202) > >> |
| Will_D:
Question: Has anyone used and calibrated the Backlash parameters #437 to #445? If so do they work? |
| Merlin201314:
Someone in another forum try, he said they works great for him, but honestly i do not use them as i do not have backlash in my axis. |
| awemawson:
--- Quote from: Merlin201314 on November 27, 2016, 08:12:00 AM ---Someone in another forum try, he said they works great for him, but honestly i do not use them as i do not have backlash in my axis. --- End quote --- You may not be able to measure it, but trust me you DO have backlash :lol: |
| Merlin201314:
I do agree with you, but as i changed the ballscrew for the C0 grade, even if my backlash is 0.004 (and should be less as the ballscrews are pre-charged) i cannot measure it as my caliper do only 0,01..... so i do not have backlash :ddb: |
| Simon0362:
Hum......... After all of the uploading, downloading and all the rest of the jazz, I seem to have lost the parameters that I setup the DDCSV1 with..... I have at least one image of the firmware contents, does anyone know which file contains the actual settings (like steps per mm, etc) and how - if possible - I can use this to replace the default numbers. Otherwise I will have to start again from zero which is *not* my Sunday evening plan.... :( |
| Navigation |
| Message Index |
| Next page |
| Previous page |