The Shop > CNC
The basics
PK:
That's a neat install
Imagineering:
Counterweight System for my SX3 CNC Conversion as promised.
Joules:
Excellent, multi story milling. Re purpose some of those old lift panels.
4: Setup and air cutting
3: Fine surfaces and finishing
2: pockets and slots
1: profiles and loose parts
B: Bed
£££: Below Bed
Will_D:
--- Quote from: John Stevenson on July 26, 2016, 06:13:34 PM ---Rubbish, Read up on this thread
http://www.model-engineer.co.uk/forums/postings.asp?th=119249&p=2
Where only tonight I mocked up a SX2P to take ball screws.
--- End quote ---
Many thanks John for this link. What a co-incidence!
I will try the Delrin EvaNuts first and see how that goes. I may well do a few mods to the X2 and the ball screws.
I see you used 1605s would you recommend these over 1204s?
spuddevans:
I used 1605's on my X2 cnc conversion, http://madmodder.net/index.php/topic,3535.msg40209.html#msg40209 shows the X axis ballscrew and nut fitting.
Tim
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version