| Gallery, Projects and General > Project Logs |
| home made mill |
| << < (18/23) > >> |
| NormanV:
:thumbup: |
| mattinker:
:thumbup: |
| Fredbare:
Well done Bob John |
| doubleboost:
:thumbup: |
| krv3000:
hi all will throw this out there on the mane shaft that's the silver one in the pick on the top there shod be a ejector nut its a 16mm by 1 mm pitch thread with a hole in it witch you un do the draw bar when the draw bar hits this it shoves the morce taper free has any one got one they can do a drawing off so I can make one up the manufacture name plat sits right behind the shaft and was well beaten up as people had bin hitting the draw bar with a hammer and the plate at the same time I have removed the name plat as the motor is gnaw 240 volt still kept the plate im going to put a pace of stanles steel in its place hopefully this week end |
| Navigation |
| Message Index |
| Next page |
| Previous page |