Gallery, Projects and General > Project Logs

home made mill

<< < (9/23) > >>

krv3000:
hi I will get the in fo off the motor tomorrow the length of the extension is 6 inches mad it that long so the mill head will cover the with of the table from front to back  im going to clock the head in tomorrow night so their will be sum pics of that on tomorrow    thanks all for the comments

krv3000:
hi all just a bit more clocked the head in tonight I had to put sum 0.25 mm shim in the top you will see them in a pic to tilt the colam over to clock it in put the vice on and clocked that in to I need to make sum t nuts up right the in fo  on the motor is sa follows TYPE AOR-63-4
D/M 0.18 volt 440 amps 0.55    55Hz U/min 1380 KW 0.24   N.R 617103 and the make of the motor is wiener starhstrom  werke right pics   

John Rudd:
Bob,
For your motor capacitor, you most use an Steinmetz connection, the capacitor value could be calculated by the following:



C = 36*P* [(220/U) Squared] * 50/f where: C is microFarads, P is motor power output in kW, U is the single phase voltage and f is frequency in Hertz.

krv3000:
er ok  electrics  baffle me thanks for the help   

John Rudd:
Bob,

Doesn't the cap you robbed of your other machine have a value marked on it?

Is the motor definitely three phase?

I'll do the calc and tell you the value of the capacitor you need....

Navigation

[0] Message Index

[#] Next page

[*] Previous page