Gallery, Projects and General > Gallery

Tooshed's Lathe Faceplate

<< < (3/3)

Toolshed:
To a slight degree, Yes.  I kept the numbers even so they would be opposites.  As far as making sure every ring matched with the other rings not really.  I "tried" to make sure they didn't all line up excepting the 4 and 12 rings, because I wanted those to be the endpoints if I wanted to cut 4 slots.  You can see how those line up on the rough sections

I doubt I would be getting near speeds where it would matter much.  That, and most of the stuff I produce isn't of the quality that would even be noticed.  I produce parts for myself, and those are typically tested to failure rather quickly.

I haven't even had time to use this thing.  Busy with other projects.

Navigation

[0] Message Index

[*] Previous page