Gallery, Projects and General > The Design Shop

Sine Plate plans

<< < (4/4)

PekkaNF:
Haa...I am an electrical engineer and I used to program industrial PLCs, but some reason I am involved mostly on mechatronics. I know very little a lot of stuff and whole lot many stuff that has absolutely no hobby use! Most of the social fuctions I don't tell that I am an engineer, because everybody thinks that I am a sadist that designs remote controllers and smart phones.....

Anyway, often online calculators will let you try out several values:
http://www.custompartnet.com/calculator/drilling-speed-and-feed
http://www.kennametal.com/en/resources/engineering-calculators/holemaking-calculators/torque-thrust-power.html

Pekka

Navigation

[0] Message Index

[*] Previous page