The Breakroom > The Water Cooler

Did make a find. =)

<< < (3/3)

PeterE:
NeoTech,

Way back when I was using a SAJO 53 UF mill at Chalmers University we had a very similar facemill to your 16-bit one. Ours was a 12-bit and the SAJO with 4HP didn't have any problems with that.

So I guess that if you don't take overly large cuts your 16-bit facemill will work on your mill as well It leaves a very nice surface afterwards!

/Peter

howsitwork?:
Nice

I've a 7 tooth maydown one running on a 2hp mill and finish is good .Only tried small depth of cut, effectively a multi-toothed fly cutter but it works! :med:

Pete.:

--- Quote from: NeoTech on March 30, 2016, 04:23:29 PM ---
--- Quote from: Pete. on March 30, 2016, 02:55:36 PM ---Do you have spare inserts for that facemill? They look very similar to some that I have got.

--- End quote ---

Yeah I have 2 sets of extra inserts, it's SNMK insert, square  ones without holes in the middle. =)

--- End quote ---

Aah, sadly mine are different :(

Navigation

[0] Message Index

[*] Previous page