| The Breakroom > The Water Cooler |
| Did make a find. =) |
| << < (3/3) |
| PeterE:
NeoTech, Way back when I was using a SAJO 53 UF mill at Chalmers University we had a very similar facemill to your 16-bit one. Ours was a 12-bit and the SAJO with 4HP didn't have any problems with that. So I guess that if you don't take overly large cuts your 16-bit facemill will work on your mill as well It leaves a very nice surface afterwards! /Peter |
| howsitwork?:
Nice I've a 7 tooth maydown one running on a 2hp mill and finish is good .Only tried small depth of cut, effectively a multi-toothed fly cutter but it works! :med: |
| Pete.:
--- Quote from: NeoTech on March 30, 2016, 04:23:29 PM --- --- Quote from: Pete. on March 30, 2016, 02:55:36 PM ---Do you have spare inserts for that facemill? They look very similar to some that I have got. --- End quote --- Yeah I have 2 sets of extra inserts, it's SNMK insert, square ones without holes in the middle. =) --- End quote --- Aah, sadly mine are different :( |
| Navigation |
| Message Index |
| Previous page |