Home Base > Introductions
Following 'Bogstandard'!
spuddevans:
Well done, that man :clap: :clap: :clap: :clap: :clap: :clap: :clap: :clap:
Some lovely work there.
Tim
Bernd:
Well Floyd after seeing those last two pieces of work I think the collective :borg: will let you stay. :lol:
Very nicely done. I like the flywheel on the second picture.
Bernd
Darren:
Nice, :headbang:
I like the notches... :)
TFL45:
Oops - sorry folks! :( Guess I should have been a bit clearer. :doh:
The Graham Industries kits come already machined, so I can take little credit for the outcome - other than following the detailed instructions for their assembly. Like to be able to claim otherwise but just ain't so! :hammer:
Floyd
Divided he ad:
Glad you liked the pic' post Floyd :thumbup:
The two engines you posted last, al be it pre-machined are nice looking..... Are you going to attempt to make similar from bar stock?
You might want to think about posting some of your engines in the gallery? They might not get seen here.... I suppose a nice Mod' might move them for you? :poke:
I really like the red hand made engine... Do you happen to have a video of it running?
Taig lathe is the same as a peatol in this country, I have one.... Haven't really used it since I got my 9x20..... I might get it out and give it a whirl... It is a very accurate little machine :thumbup:
Glad to see you have found your feet :ddb:
Ralph.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version