| Gallery, Projects and General > Gallery |
| Flyer |
| << < (2/3) > >> |
| DMIOM:
--- Quote from: Brass_Machine on March 29, 2016, 03:03:13 PM ---Nice piece! err... what's it do? --- End quote --- I'm guessing its for this: http://madmodder.net/index.php/topic,10127 |
| Ginger Nut:
--- Quote from: raynerd on March 30, 2016, 06:22:53 AM --- --- Quote from: Brass_Machine on March 29, 2016, 03:03:13 PM ---Nice piece! err... what's it do? --- End quote --- :smart: --- End quote --- Its for LOML's spinning wheel when mounted in its right full place it does this. |
| Ginger Nut:
--- Quote from: DMIOM on March 30, 2016, 07:27:00 AM --- --- Quote from: Brass_Machine on March 29, 2016, 03:03:13 PM ---Nice piece! err... what's it do? --- End quote --- I'm guessing its for this: http://madmodder.net/index.php/topic,10127 --- End quote --- Thats the one thanks. |
| texta:
good job mate should score you a brownie point or 2 , but and there is always a but aint there i think it will break very easy on the cross grain section at the bottom of the U probably would of been better made for 2 or 3 bits of wood laminated with the grain at 90 degrees to each other or even made with an off cut of good ply wood .that aside i hope it stays in one piece and lasts forever and i am wrong about the weak point on the cross grain . johno |
| Toolshed:
NICE work! I've been wanting to build a spinning wheel for my better half. We both do fiber arts and she's been wanting to spin forever. Kentucky is big into breeding alpacas for their fur. |
| Navigation |
| Message Index |
| Next page |
| Previous page |