The Shop > Tools
Feeler Lathe
Rick O Shea:
I have just pushed the boat out, spent most of the children's inheritance, and bought a very nice Feeler lathe. Which is as far as I can see a Hardinge copy made in the far east , it has a very good write up in Lathes website and looks beautiful it is in fantastic condition having been rebuilt by Hardinge a few years ago.
I suspect lots of people use Hardinge but do many have Feelers? I have a maintenance manual but not an instruction manual. can any offer any pointers or advice?
awemawson:
Looks very nice.
Quite surprised that Hardinge were prepared to re-build a copy of one of their products :scratch:
Rick O Shea:
I am not sure about that either.
Some authorities suggest that Hardinge licenced the far east copy? again all I can say is that the quality of the lathe is superb, not a far east knock off copy but a beautifully made machine. Did hardinge supply patterns ? I have no idea
BillTodd:
I suspect ZMT rather than hardinge did the rebuild (don't think H.UK do rebuilds of anything) .
>Some authorities suggest that Hardinge licenced the far east copy?
Hardinge denies it ;-)
looks great :-)
ii think i have a manual somewhere....
It's a near clone of the Hardinge so the HLV-H manual will tell you all you need:
https://drive.google.com/open?id=0BwXDcXKx2Kzld3BVak1tV2o3eGc
Here's a service/operation manual for the cyclematic 618 english/metric for anything different (e.g. dials )
https://drive.google.com/open?id=0BwXDcXKx2KzlZVZ5NWdHeGdBYjA
Rick O Shea:
Thanks Bill the manual will be a great help. I think you are right it may well have been ZMT who did the refurb. I thought it was done in Exeter but Bovey Tracy is very close, so may be the sellers memory playing tricks
I am going to need a couple of back plates for the odd chucks I have got where do you suggest I could try?
very best wishes and thanks
Mike
Navigation
[0] Message Index
[#] Next page
Go to full version