Gallery, Projects and General > Project Logs

Grinding in't mill

(1/2) > >>

chipenter:
I have made a pair of 1 2 3 blocks and decided to grind them to the finished size , made a mandrill for 80mm silicon wheel and tried it works very well and a good finish , the only problem was the stone wears quickly as it's small , and I spent more time messuring than grinding .

awemawson:
Brave man  :bugeye:

Looks good  :thumbup:

NeoTech:
This is usually not that bad, that everyone thinks it is.. You dont relly need to cover EEEVERYTHING either.. just make sure it doesnt get into the leadscrews.. I used a thick grease as dust traps and got rid of it with alcohole when i was done.

DMIOM:

--- Quote from: NeoTech on February 24, 2016, 04:27:33 AM ---..... and got rid of it with alcohole when i was done.
--- End quote ---

Was that to wash the dust out of your throat?     :beer:   :beer:   :beer:

Dave

NeoTech:

--- Quote from: DMIOM on February 24, 2016, 05:50:21 AM ---
--- Quote from: NeoTech on February 24, 2016, 04:27:33 AM ---..... and got rid of it with alcohole when i was done.
--- End quote ---

Was that to wash the dust out of your throat?     :beer:   :beer:   :beer:

Dave

--- End quote ---

Don't drink and drive a mill or a lathe.. well anything that can take a finger off. ;D

Navigation

[0] Message Index

[#] Next page