| Gallery, Projects and General > Project Logs |
| Grinding in't mill |
| (1/2) > >> |
| chipenter:
I have made a pair of 1 2 3 blocks and decided to grind them to the finished size , made a mandrill for 80mm silicon wheel and tried it works very well and a good finish , the only problem was the stone wears quickly as it's small , and I spent more time messuring than grinding . |
| awemawson:
Brave man :bugeye: Looks good :thumbup: |
| NeoTech:
This is usually not that bad, that everyone thinks it is.. You dont relly need to cover EEEVERYTHING either.. just make sure it doesnt get into the leadscrews.. I used a thick grease as dust traps and got rid of it with alcohole when i was done. |
| DMIOM:
--- Quote from: NeoTech on February 24, 2016, 04:27:33 AM ---..... and got rid of it with alcohole when i was done. --- End quote --- Was that to wash the dust out of your throat? :beer: :beer: :beer: Dave |
| NeoTech:
--- Quote from: DMIOM on February 24, 2016, 05:50:21 AM --- --- Quote from: NeoTech on February 24, 2016, 04:27:33 AM ---..... and got rid of it with alcohole when i was done. --- End quote --- Was that to wash the dust out of your throat? :beer: :beer: :beer: Dave --- End quote --- Don't drink and drive a mill or a lathe.. well anything that can take a finger off. ;D |
| Navigation |
| Message Index |
| Next page |