Gallery, Projects and General > Project Logs
X2 CNC Conversion
Brass_Machine:
Ordered some more stuff today. I ordered the steppers for the x & y, the 4th axis update for my controller, flexible anti backlash couplings, E stop switch.
Will try to finish the controller this week. I need an enclosure and power supply next.
Eric
SPiN Racing:
Ahhhhhhhh (Looks for Smiley with a Lightbulb over his head)
Yes.. I see. Smaller Mill. Good for CNC machining of small intricate parts. CNC engraving.. on and on.
Will be a really nice piece to have. Not really gonna translate to the Chinabridge very well. :ddb:
Brass_Machine:
Yeah Scott... smaller mill is an understatement. Not quite the smallest you can buy, bet pretty darn close. I think it weighs in at about 150lbs or so. I can really afford anything bigger right now nor do I have the room. I know I can fit a X3 (or the new X4) perhaps a RF45 (that would be pushing it) down in my shop. I have to wait till I rebuild my garage first.
But as it is, it is big enough for now. I really don't mill anything too big.
Eric :borg:
zeusrekning:
Eric, Im glad to see you have started on this project. I know it has been a while comming. Good luck and I will be watching.
Tim
Brass_Machine:
Another package arrived yesterday. This one had the steppers for the X & Y, E stop and a coupler. The steppers are 425oz/in in bipolar 305oz/in in unipolar. Unfortunately, the controller I have is unipolar only. No big deal.
I hope to have another package come in today... fingers are crossed.
Eric
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version