| The Shop > Metal Stuff |
| "Any Old Iron?" - A Reminiscence from Forty Years Ago! |
| (1/2) > >> |
| Pete W.:
Hi there, all, There's currently a listing on eBay for a 'Small Lathe Stand, Home Made from an Old Bedstead'. The picture shows it's a bolted construction. That too me back about forty years to when I was establishing my workshop. I collected all sorts of raw material including 'angle iron' cut from the frames of old bedsteads. One common brand was 'Vono' - if I remember correctly, the adjacent sides of the frame were joined at the corners by a cast in-situ piece that included a sort of cone on a stalk that fitted into the mating fittings on the head-board and foot-board. The story at the time was that this angle iron was re-rolled from the tram rails when the tram-tracks were taken up from the streets of London. It was very tough and stringy, as though the metal hadn't been cleaned before re-rolling so all sorts of grit and other inclusions got incorporated into the metal. It was quite un-cooperative with any attempts to cut or drill it. My neighbour had a stick welder but neither he not I were welders so our welding difficulties might have been due to the material or to our incompetence or to some combination of the two!!! :scratch: :bang: :scratch: :bang: :scratch: :bang: Did anyone else experience this material? How did you fare? |
| awemawson:
Pete, it's not an urban myth. Tram rails were high in manganese so that the rolling surface 'work hardened' in use. Loads were re-rolled and not just from London - Absolute bugg @@ to drill through - rather like some stainless steels.( I used to go to school in Leeds on a Tram.) As for Vono beds - my bed as a young child up to the age of 9 was a Vono - there was a cast (really rather too tapered) spanner to tighten the nuts. I re-met the Vono's when I went to boarding school and most of the beds in the dormitories were the same style except in the Sanatorium where they were ex army tubular ones. |
| DavidA:
Pete, Ah yes, the dreaded 'bed frame iron'. It is indeed hard to saw and drill, but also seems to be quite strong. I have used it a lot, but things became easier with the advent of the angle grinder and 1mm slitting discs. Dave. |
| hermetic:
Still got some Vono bed frame angle, built a grass racer chassis out of it in the seventies, very springy and as everyone has said, an absolute sod to drill or saw. I thought it welded pretty ok, I was using a stick welder cobbled together out of a "welders mate" DC welder, and a matching transformer producing AC........but it worked :D |
| mcostello:
Same story over across the pond. Some say not weldable, the rest of us just get it done with no problems. |
| Navigation |
| Message Index |
| Next page |