The Shop > Software Tools
Feeds & Speeds Calculators
wheeltapper:
I just found this.http://www.custompartnet.com/calculator/milling-speed-and-feed
Is it any use to you?
Roy.
awemawson:
That's a nifty little gizmo Roy - thanks :beer:
Shame it seems only to be Imperial units :med:
philf:
--- Quote from: wheeltapper on February 06, 2016, 07:05:57 AM ---I just found this.http://www.custompartnet.com/calculator/milling-speed-and-feed
Is it any use to you?
Roy.
--- End quote ---
--- Quote from: awemawson on February 06, 2016, 07:09:12 AM ---That's a nifty little gizmo Roy - thanks :beer:
Shame it seems only to be Imperial units :med:
--- End quote ---
Hi Roy/Andrew,
The trouble with a lot of such calculators is that you have to enter "Feed Per Tooth" which seems to be rarely published anywhere.
Phil.
awemawson:
Chip load seems to be the way to go :scratch: :coffee: :coffee:
awemawson:
Well I've been lead badly astray by another member :bugeye:
Rob Wilson lead me into temptation, let me peep round the curtain concealing desirable objects and I transgressed and bought this little toy :
http://www.ebay.co.uk/itm/231539063590?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
On the face of it well OTT for my use, but SO convenient, and considering the price of end mills, and also a reasonable Gwizard subscription perhaps not so bad after all.
.... anyway you can't take it with you, and too much inheritance will only spoil the kids :lol:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version