| The Shop > Software Tools |
| Feeds & Speeds Calculators |
| << < (2/4) > >> |
| wheeltapper:
I just found this.http://www.custompartnet.com/calculator/milling-speed-and-feed Is it any use to you? Roy. |
| awemawson:
That's a nifty little gizmo Roy - thanks :beer: Shame it seems only to be Imperial units :med: |
| philf:
--- Quote from: wheeltapper on February 06, 2016, 07:05:57 AM ---I just found this.http://www.custompartnet.com/calculator/milling-speed-and-feed Is it any use to you? Roy. --- End quote --- --- Quote from: awemawson on February 06, 2016, 07:09:12 AM ---That's a nifty little gizmo Roy - thanks :beer: Shame it seems only to be Imperial units :med: --- End quote --- Hi Roy/Andrew, The trouble with a lot of such calculators is that you have to enter "Feed Per Tooth" which seems to be rarely published anywhere. Phil. |
| awemawson:
Chip load seems to be the way to go :scratch: :coffee: :coffee: |
| awemawson:
Well I've been lead badly astray by another member :bugeye: Rob Wilson lead me into temptation, let me peep round the curtain concealing desirable objects and I transgressed and bought this little toy : http://www.ebay.co.uk/itm/231539063590?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT On the face of it well OTT for my use, but SO convenient, and considering the price of end mills, and also a reasonable Gwizard subscription perhaps not so bad after all. .... anyway you can't take it with you, and too much inheritance will only spoil the kids :lol: |
| Navigation |
| Message Index |
| Next page |
| Previous page |