The Shop > Tools

Harrison L5A a new life

<< < (2/2)

Biggles:
Whilst waiting for things to be constructed in the loft  :hammer: I have been busy working my keyboard and spending some money before it burns a hole in my pocket. Can’t have the wife sowing pockets! I found the following items and relocated them to my house. An Elliott P2 pillar drill, Clarkson mark 2 Grinder, Harrison Fluid feed and Main Lock nuts of the main spindle, a Spacing bush, a working 240v Cole Ace grinder and a Duplex grinder for spares which I intend to get working, I hope.  :loco:
The Clarkson and Elliot are both 3 phase. I haven’t had them going yet as I don’t have a 3 phase supply. Eventually I will refit them after I finish the lathe.
                                                                                                                                                                    :mmr:
 
My lathe did not have the end cover and the main spindle locknuts were abused.



A Harrison fluid pipe and fitting.




Dual reading micrometre hand wheels and screws.


Duplex grinder (non working)



Ace Cole grinder in working condition.



A Clarkson mark 2 grinder.



An Elliott 2 Progress floorDrill.

micktoon:
Looks like you have won the lottery lol :thumbup: some nice new kit there so should enhance you workshop no end. Hope the Harrison is coming on nicely too.
 Cheers Mick

Biggles:
I wish Mick; just had to have them come what may, especially the feed screws and dual micrometres. I haven’t touched the lathe since i gave the compound to a friend to sort out the chips and new Gibs. With any luck i will do some work on it this week if i am not laid out cos of my back and a myriad of other things i have to do.  :thumbup:

Navigation

[0] Message Index

[*] Previous page