Gallery, Projects and General > How do I??

Drilling small holes

<< < (5/5)

Darren:
John K,

Though it's hard to tell from the picture those drill bits look very much like these http://madmodder.net/index.php?topic=853.msg6724#msg6724

Darren:
Just thought I'd pop this in,  :D

I took an old 1.5mm drill bit and ground the "other" end to form a D bit.
It went in ok and didn't snap or anything, but what it did do was push it's way through rather than drill. It's not very clear in this pic, but you should be able to see how the sides of the piece have bulged out.

I realise it's not a proper D bit but thought I'd show and tell all the same..... :ddb:



It's of no matter now as I have started with some new material that is behaving itself  :ddb:

Navigation

[0] Message Index

[*] Previous page