| Home Base > Introductions |
| Hi there from yet another newbie |
| << < (3/4) > >> |
| Bernd:
Tim, Elmers #25 Wobbler was my first engine build. A fun engine to make and very easy. But there are lots of choices out there. Regards Bernd |
| spuddevans:
Thanks for the suggestion Bogs, --- Quote from: Bernd on May 04, 2009, 08:47:42 AM ---Tim, Elmers #25 Wobbler was my first engine build. A fun engine to make and very easy. But there are lots of choices out there. Regards Bernd --- End quote --- I'm leaning towards that one myself. Does anyone forsee any problems as I dont yet have any silver solder gear, I just have low temp solder. I notice from the plans that there seems only to be one SS joint on it in the cylinder pivot pin, could I locktite it instead? or would the low temp (plumbers stuff) solder do? Tim |
| Bernd:
Tim, I didn't use any type of solder or Loctite. I made the hole a press fit for the pin. Hasn't fallen out yet. I did a build sequence and have it on my web site at The Model Engine Shop Enjoy. Bernd |
| spuddevans:
Thanks Bernd, that link gives me a good reference to read over. Tim |
| Stilldrillin:
Welcome Tim, It`s nice `ere...... :wave: Get stuck in and enjoy it! :thumbup: David D |
| Navigation |
| Message Index |
| Next page |
| Previous page |