The Shop > Electronics & IC Programing

What leads and probes you use and where to get them.

<< < (3/3)

PekkaNF:

--- Quote from: PekkaNF on January 31, 2016, 03:53:42 PM ---I 'think' I found economical crimpper plier to these pins....let's see when it arrives. Really starting to like these JST connectors.

Pekka

--- End quote ---

Got this plier home and it seems to work, first one I stripped too long.
http://www.ebay.com/itm/321383053381

PekkaNF:
And got cheap signal geneator up to 24MHz to check if the connectors/cables/termations are any good for the speed.

Since I don't have BNC-T (for termination) and BNC/BNC straight cables I gobled up BNC/terminal to two 100ohm 2W power resistors....some inductance for sure....That should be good up to few MHz.

Now: Never have done any BNC cables and all seem to have crimp connections. Should I have buy cables readily terminated and cut them if shorter pieces are needed?

Where to buy few 50 ohm BNC cables to hook up signal generator/Scope and measurement rig?

Pekka

PK:
There are a few screw together BNC cable options. They're not as robust as a crimp though...

PekkaNF:
Like some F-connectors? Novel.

I bought some readymade 50 ohm BNC/BNC cables, terminators and BNC-T:s just need to wait them to arrive and then I can test if the chinese ones I got are 50 ohm or something else.

I need to buy some 2 mm PCB test jacks (sockets?) and maching plugs. I like that safetyplug style, but it would limit suppliers and pretty much to Hirschmann. Which I don't mind if I'll get KLEPS1 size test hooks and set w/ cables on reasonable price, but googling hasn't revealed too much yet.

Pekka

Navigation

[0] Message Index

[*] Previous page