Gallery, Projects and General > The Design Shop
3D Printed Quorn Tool & Cutter Grinder
Joules:
Not worried about the grit at the moment, more interested in at least getting it working. If parts are cheap to make once its completed I will just wear them out and replace. :thumbup:
Joules:
What about seals wiping the bars ? I will give the felt a go, but can't imagine that being great at keep grit off, but I thought rubber seals might keep it at bay.
As the next major part is a 10hr print and will wait till tomorrow I have got a quicker 1hr job on the printer.
In this case the micrometer thimble. Since knurling looks naff 3D printed, I have gone for something a little better suited to 3D printing. It's been printed in black and I will try to put white paint in the numerals and graduation marks once it's done. This part is printing at 0.1mm to capture the fine detail in the numerals.
RobWilson:
is it done yet ! :D
Rob
Joules:
86%
RobWilson:
--- Quote from: Joules on December 22, 2015, 04:11:12 PM ---86%
--- End quote ---
:lol: :lol: :lol:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version