The Shop > Electronics & IC Programing

Odd problem

<< < (2/2)

DavidA:
 Yes, that cured it.  All that trouble caused by a blocked fan.

I downloaded CPUID to that machine and the CPU runs at around 30C.

So, XP re installed.  I've lost my other applications that were on the Hard Drive, but I can get them back. Most of the data files were backed up.

Oh the joy of modern technology.

Thanks for the help.

Dave.

Oh yes, Nearly forgot.
Tomorrow (Friday) I retire for the fifth and, hopefully final, time.

JD:
Dave FORGOT  :Doh: time to relax put your feet up  :lol: yeah ok, enjoy.
JD

DavidA:
JD,

In preparation for my time 'relaxing with my feet up' I spent a couple of hours in the shed today bypassing the electrical circuitry to the motor on my Denford lathe. I just wanted a direct connection to the three phase supply to see if the motor would at least run. Last time I tried using the full control board it knocked out the RCD trip.

Going to need that lathe in the near future. :thumbup:

Dave.

DavidA:
Just for the sake of accuracy I should add a correction here.

It wasn't the RCD that tripped out (as mentioned in the above post) it was the 16 Amp current overload.

Dave.

Navigation

[0] Message Index

[*] Previous page