| The Shop > Electronics & IC Programing |
| Odd problem |
| << < (2/2) |
| DavidA:
Yes, that cured it. All that trouble caused by a blocked fan. I downloaded CPUID to that machine and the CPU runs at around 30C. So, XP re installed. I've lost my other applications that were on the Hard Drive, but I can get them back. Most of the data files were backed up. Oh the joy of modern technology. Thanks for the help. Dave. Oh yes, Nearly forgot. Tomorrow (Friday) I retire for the fifth and, hopefully final, time. |
| JD:
Dave FORGOT :Doh: time to relax put your feet up :lol: yeah ok, enjoy. JD |
| DavidA:
JD, In preparation for my time 'relaxing with my feet up' I spent a couple of hours in the shed today bypassing the electrical circuitry to the motor on my Denford lathe. I just wanted a direct connection to the three phase supply to see if the motor would at least run. Last time I tried using the full control board it knocked out the RCD trip. Going to need that lathe in the near future. :thumbup: Dave. |
| DavidA:
Just for the sake of accuracy I should add a correction here. It wasn't the RCD that tripped out (as mentioned in the above post) it was the 16 Amp current overload. Dave. |
| Navigation |
| Message Index |
| Previous page |