The Shop > Our Shop

Another machine joins the stable...

<< < (6/9) > >>

nrml:
Looks like another epic CNC lathe thread is about to start :drool: :clap: :headbang: :nrocks:

RobWilson:
Very nice Ade , that some  bit of kit   :bugeye:


I methinks the Butt plug E stop may need fitting for the first test run  :lol:   


Rob

AdeV:
Thank you all for your continued interest (now, if only one of you was a secret Mazak expert!!)  :lol:

Biggles - tidal power is the one, I think. Even as I write this it's lashing down with rain again, and blowing a merry gale, again. I've lost count now, but it's been roughly 1/week since sometime in November. Fortunately, we're out of harms way (even down on the docks, ironically, as the gates can be closed to keep the water out, but the Mersey hasn't flooded anyway).

nrml - Well.... maybe.... I'm not sure I've got the tenacity that Andrew's got, and I certainly don't have as much "spare" time. But I'll give it a good go!

Rob - No e-stop needed yet... need an e-start first! I'll turn the butt plug up on the old Edgwick! It cuts a taper anyway, so that saves some time  :scratch:

awemawson:
Ade, the advantage you have with the Mazak is that there are far more of them around than my Traub, so hopefully spares and knowledge should be easier to come by.

Documentation and knowledge are the key I think  :thumbup:

philf:
Ade,

Any progress on the Mazak?

Phil.

Navigation

[0] Message Index

[#] Next page

[*] Previous page