| Gallery, Projects and General > How do I?? |
| snapped centre drill |
| << < (2/10) > >> |
| Joe d:
soaking it in a warm to hot alum solution will (albeit slowly) work. Here's a picture of my set up the last time I needed to do this It will give your brass a nice weathered look, so brasso may be your friend afterwards. Joe |
| Ed ke6bnl:
where did u get the Alum |
| Joe d:
I bought it at the pharmacy, where it is stupidly expensive. If you have a WELL equipped grocery store in terms of pickling and preserving supplies, you will get a much larger container for far less than it cost me... |
| woodguy:
Bulk Barn Franchises carry it. |
| kayzed1:
Many thanks one and all, David, i can not go through from the other side as it is a Cylinder with a flat one side for the valve chest. I will give the Alum a shot in the week. Lyn. |
| Navigation |
| Message Index |
| Next page |
| Previous page |