| The Shop > Electronics & IC Programing |
| Digital oscilloscope project/kit |
| << < (20/70) > >> |
| Bluechip:
--- Quote from: RobWilson on December 31, 2015, 01:47:06 PM ---Cheers Dave , It must be beer O'clock :beer: Rob --- End quote --- What a coincidence, my clock says just the same ... :beer: Must have batteries from the same batch. Dave |
| RobWilson:
:) :thumbup: Rob :beer: |
| John Rudd:
Rob, Make the tracks as thick as they can be..... Then fill the voids with a copper fill......etching a board wont take as long as theres less to etch away... |
| wheeltapper:
Hi all I received the smd practice board this morning and have finished most of it. I haven't soldered the transistors or the IC yet as they play no part in the test circuit, however putting 15 volts through it lights the LED so I did something right. I will solder them in anyway just for more practice because there is an IC on the scope board. It was reasonably easy much to my surprise, the 0603 resistors were the hardest but they all went on OK. I now have the confidence to press on with the scope kit and the tester kit. I'll see if I can get a decent pic to show. cheers Roy. |
| RobWilson:
Nice one Roy Good to hear the SMD soldering practice went ok :headbang: you must have bloody good eyes. Rob :beer: |
| Navigation |
| Message Index |
| Next page |
| Previous page |