The Shop > Electronics & IC Programing
Digital oscilloscope project/kit
kayzed1:
Tis the second board io have on these, if you want it PM me your address...
Lyn.
RobWilson:
The Signal generator project arrived from Banggood yesterday , so I welded all the bits together today :zap:
Cant test it until I build a power supply for it :coffee: , also the PSU circuit diagram I posted earlier has a couple of faults :Doh:
#1 the supply needs to be more like +18 - 18 volts as a 12 regulator needs more than 12 volts
#2 the -12 rail needs a 7912 voltage regulator not a 7812 ,the 7912 is a -12v reg .
Cheers Rob
RobWilson:
Going to cobble together something like this :zap: :zap:
Rob :coffee:
John Rudd:
Rob,
Nicely assembled... :clap: Looks pretty neat and tidy....Hope it works for you..... :zap:
Just be aware that the pin outs for 78 and 79 v regs are different.......
The + 12v reg may need a heatsink on it too as its supplying current for the 9 & 5 v regs....
RobWilson:
--- Quote from: John Rudd on December 30, 2015, 12:43:57 PM ---Rob,
Nicely assembled... :clap: Looks pretty neat and tidy....Hope it works for you..... :zap:
Just be aware that the pin outs for 78 and 79 v regs are different.......
The + 12v reg may need a heatsink on it too as its supplying current for the 9 & 5 v regs....
--- End quote ---
Cheers John , if you see the northern lights tis just me going up in smoke :lol:
The reg pinout got me on the simulation ,,,,,,,,,,was wondering why I was getting -18v when it should have been -12 v ,,,,,,,,,,,,,,had the 7912 wired wrong :palm:
I have ordered heatsinks for all the regs :thumbup:
anything else you or anyone could recommend to improve things ? :wave:
Cheers Rob
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version