The Shop > Electronics & IC Programing
Digital oscilloscope project/kit
wheeltapper:
I'll go back out to my shop when my skin stops freezing to the machinery. :bugeye:
Roy.
PekkaNF:
Very tempted to buy one oscilloscope kit. There does not seem to be external triggering. I was checkking the same type two channel scopes (could use another channel for triggering and it would show the trigger point on the screen) but they were whole lot more complicated or too expensive to justify.
I checked some readymade modules too, they don't look much better on display or sampling rate.
Pekka
John Swift:
I guess you could duplicate the Y amp up to TP3
disconnect R13 from TP3 and add a switch to select Y or external trigger source
krv3000:
brill
John Stevenson:
You need a decent heater in the shop.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version