| The Shop > Electronics & IC Programing |
| Digital oscilloscope project/kit |
| << < (24/70) > >> |
| RobWilson:
--- Quote from: John Rudd on January 01, 2016, 07:32:32 AM ---Rob, ESR do a line in pcb trannies.......but I guess you aleeady knew that..... They aint to far from you either at Cullercoats....( boy I love going to that place....lots of luverly conponents.... :lol:) --- End quote --- I keep forgetting about ESR John :bang: , they are only a few miles away . Rob |
| Bluechip:
Here you are, Rob. PCB Tranny now in. Looks a bit messy :scratch: Back to my Becks & cashews .. :beer: Hope I've got 'em re-sized properly. Dave EDIT1 Near enuff ... :loco: EDIT2 Each dot is on a 0.1" pitch |
| RobWilson:
Lookin good Dave :thumbup: My electronics /PCB software can't do a ground plane :scratch: I could not agree more ,,,,,,,,,,,,where be my beer :beer: Cheers Rob |
| John Rudd:
Dave, I know you done well...... :bow: But I think the distances between the copper infill are a bit close around the transformer.... :scratch: I prefer at least 6mm creepage distance for safety... :zap: Just my 2 cents....while drinking my Carling cider.... :coffee: Enjoy.... :) |
| philf:
--- Quote from: RobWilson on January 01, 2016, 02:42:01 PM --- My electronics /PCB software can't do a ground plane :scratch: --- End quote --- Rob, Are you sure? I managed to do a copper pour to fill. What i couldn't do was neatly connect a pad to the plane. I've uninstalled it now so can't tell you exactly how to do it. :beer: Phil. |
| Navigation |
| Message Index |
| Next page |
| Previous page |