Gallery, Projects and General > Gallery

Angle drilling a hole in brass

<< < (2/2)

sparky961:
Deja-vu, anyone?

http://madmodder.net/index.php/topic,11043.msg128265/topicseen.html#new

As I mentioned in the thread above, the method you chose is highly dependent on the level of accuracy you need.  The fact that it's brass is inconsequential.  Have a look at the thread linked above and if that doesn't give you enough ideas then post a lot more detail on what you're trying to accomplish.

NeoTech:
haha apparently, i havent read that thread yet.

I usually never drill a angled hole at all, i just put a 2 flute or single flut mill in my drill press instead.. and run it down until i got a proper flat surface to start my drill at.
But i only been doing propane burners, those swirly bits in the burner head.

Navigation

[0] Message Index

[*] Previous page