| Gallery, Projects and General > Gallery |
| Angle drilling a hole in brass |
| << < (2/2) |
| sparky961:
Deja-vu, anyone? http://madmodder.net/index.php/topic,11043.msg128265/topicseen.html#new As I mentioned in the thread above, the method you chose is highly dependent on the level of accuracy you need. The fact that it's brass is inconsequential. Have a look at the thread linked above and if that doesn't give you enough ideas then post a lot more detail on what you're trying to accomplish. |
| NeoTech:
haha apparently, i havent read that thread yet. I usually never drill a angled hole at all, i just put a 2 flute or single flut mill in my drill press instead.. and run it down until i got a proper flat surface to start my drill at. But i only been doing propane burners, those swirly bits in the burner head. |
| Navigation |
| Message Index |
| Previous page |