The Shop > Tools
My Squaring Gauge/Indicator Stand
Stilldrillin:
WOW! :bugeye:
That's a handy, easily made weapon!
Thanks for showing. And, for showing your build, Sparky..... :thumbup:
David D
Arbalist:
I too have seen the video before and have a very nice scriber block but I've been loathe to start cutting slots in it. If anyone comes up with a mod that doesn't damage the block so much let me know! :thumbup:
Manxmodder:
--- Quote from: Arbalist on October 19, 2015, 06:04:59 AM ---I too have seen the video before and have a very nice scriber block but I've been loathe to start cutting slots in it. If anyone comes up with a mod that doesn't damage the block so much let me know! :thumbup:
--- End quote ---
Perhaps bonding a piece of brass angle to the front and bullnosing it would be more acceptable than cutting a slot in your block......OZ.
Arbalist:
I notice Phil said he used "Gauge Stock" which over here is 01 tool steel so I guess some mild steel should be fine, it's only rolled over the work. Maybe I could epoxy some magnets to a piece of angle instead?
Stilldrillin:
--- Quote from: Arbalist on October 19, 2015, 10:28:16 AM ---I notice Phil said he used "Gauge Stock" which over here is 01 tool steel so I guess some mild steel should be fine, it's only rolled over the work. Maybe I could epoxy some magnets to a piece of angle instead?
--- End quote ---
I wouldn't!
I hate using, accidentally magnetised tooling........ :palm:
David D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version