Gallery, Projects and General > How do I??

Clamps for a Height Gauge Scriber?

<< < (2/2)

sparky961:
As an afterthought, and further to my earlier suggestion, the arm on your gauge seems thicker than average. It turns out I only have 2 clamps but they measure considerably smaller than what you're looking at. (0.780 x 0.350, 0.895 x 0.360)

Manxmodder:
My preferred routes would be to thin down the scriber stem by 0.110" or slim down the outrigger arm on the height gauge by the same amount. That would,I think be easier options than making a new clamp from scratch......OZ

Jasonb:
How much scriber height can you fit under the stub, there is not a lot of adjustment of Zero so before making a bigger clamp check that when the scriber is touching the marking table its not reading 0.100".

I'd take the metal off the bottom edge of the scriber arm if he height is OK.

Navigation

[0] Message Index

[*] Previous page