| Gallery, Projects and General > Project Logs |
| Edwick lathe four jaw mount. |
| << < (2/2) |
| mattinker:
Thanks for the comments! --- Quote from: DMIOM on September 24, 2015, 03:01:52 AM --- --- Quote from: mattinker on September 23, 2015, 03:36:54 PM ---....... The marking rings are 1/2" apart and numbered from 3 to 10, strange! ........ --- End quote --- Are they perchance a guide as to diameter in inches? i.e. if inside jaws were on the 6 would it be ready to grasp a 6" OD item? / if the outside jaws were on the 10 would it be ready for a 10" ID item? Dave --- End quote --- Dave The rings are 1/2" apart, 10 is marked on the inside of the first ring, not on the outer edge! It's a 12" chuck. I haven't found the explanation yet, it might take some time as I work in millimetres! Regards, Matthew |
| Manxmodder:
Great bit of resourceful engineering ,Mathew. :clap: :clap: ......OZ. |
| mattinker:
Thanks Manx! |
| Navigation |
| Message Index |
| Previous page |