Gallery, Projects and General > Member Videos
Making a sand mold without a pattern
vtsteam:
In this case it's the multi piece core-box that avoids the need for draft. Casting in a core doesn't necessarily avoid draft. This whole molding session taken together for the particular purpose is very cool. :clap:
mattinker:
--- Quote from: joshagrady on September 09, 2015, 12:27:31 PM ---Nice looking casting.
I assume that the advantage to using cores rather than a pattern is to avoid draft angles? Or is it just faster?
Thanks for posting.
--- End quote ---
Not only does it avoid draft, but the core boxes are much easier to make than a patern!
Regards, Matthew.
Navigation
[0] Message Index
[*] Previous page
Go to full version