| Gallery, Projects and General > Project Logs |
| Potty Grasshopper Engine |
| << < (5/9) > >> |
| krv3000:
oooooo nice |
| mexican jon:
:nrocks: Awesome work :thumbup: With a capital A :clap: :clap: :clap: |
| sbwhart:
Thanks for your support Chaps. Next bit the eccentric arm decided to keep the circle theme going. So turned up and parted off some rings with their diameters receding in size drill 1/16 and threaded on a bit of wire as before. The final was turned up and threaded M3 and shaped to blend in with the circle. It was also drilled 1/16 and threaded on the wire. And the whole lot silver soldered together, whist it was in the pickle made the valve rod handle fron 3/8 square bar. Faced off centre drilled and drilled at tapped M3 Then drill a 3mm hole off centre slightly to help keep it on the valve rod/ Formed the other end up into a nice handle shape. Thinned the width down to 1/4 Cut a slot to take the Valve rod. And this is it finished. And where it will roughly sit on the engine. Cheers Stew |
| Joules:
Oh NO..... yet more machine porn :bugeye: Why oh why do I open these threads...... |
| Stilldrillin:
Oh, my........ :palm: Well done. Again! :thumbup: :clap: :clap: David D |
| Navigation |
| Message Index |
| Next page |
| Previous page |