The Shop > Tools

Real Bull Mini-lathe Speed Controller Woes

<< < (5/5)

Stilldrillin:
RESULT!!

Well done, all......  :clap: :clap:

David D

DMIOM:
The MM community at its best  :clap:  :clap:  :clap:  :clap:  :clap:  :clap:      :ddb:   :ddb:   :ddb:     :mmr:

Ross:
Couldn't be happier cheers lads you are all stars!

picclock:
Hi Ross

Glad you resolved your pot problem. Speed reading intermittent could just be an adjustment of the opto sensor. I assume it has the sensor and light interrupter disc on the end of the spindle. The pcb and bracket are normally mounted on slots and can be adjusted radially. They should be set so that the bottom of the sensor gap just misses the edge of the interrupter. Stray light may also affect it if you are using it without a cover.

Best Regards

picclock

Navigation

[0] Message Index

[*] Previous page