The Shop > Tools

Tinker tool and cutter grinder

<< < (4/4)

chipenter:
I had an old spindle that was bent in a lathe , trued the taper mounted between centres and turned down to my largest reamer size , a piece of 1 12" square bored and reamed , driled and taped cleaned up and I have a mt3 shaft and found a use for the old one a ball turning tool no less .

chipenter:
Finaly sharpened the flutes on a end mill , mounted the jig on an old cross and tool slide and raised the grinder , it needs to be raised another 20mm , then I can use a square to set the angles insted of tangently witch is a bit of a fiddle .

Navigation

[0] Message Index

[*] Previous page