Gallery, Projects and General > How do I??
Roll pin removal
awemawson:
Can you start a self tapping screw in it, and lever it out using the head. Self tappers are pretty hard steel. Obvious you don't want to go in too far and expand the pin much.
If you are really stuck post it to me and I'll pop it ou on the die sinker edm.
John Rudd:
--- Quote from: awemawson on July 22, 2015, 12:23:40 PM ---
If you are really stuck post it to me and I'll pop it ou on the die sinker edm.
--- End quote ---
Hmm. Thought you might... Thanks for the offer Andrew.... All is not lost... Yet!...
I'll give the s-t a go if the Ezi Out doesn't....
lordedmond:
John
That's similar to a Myford top slide
It's only a antirotation pin just press out the stud from the top then you can deal with the pin as it will be accesible
Stuart
awemawson:
It's not entirely clear to me how that is assembled. Is the upper part screwed to the lower part with the pin or what.
If so can one or the other be firmly gripped in a collet, and the pin sheared off so that it can be removed in two parts ?
Cross sectional C o Cad sketch please :ddb:
John Rudd:
--- Quote from: Stuart on July 22, 2015, 12:30:29 PM ---John
That's similar to a Myford top slide
It's only a antirotation pin just press out the stud from the top then you can deal with the pin as it will be accesible
Stuart
--- End quote ---
I tried pressing it out.....won't budge.....grrrr.
The pin is 3mm dia and 16 mm long according to the manual....
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version