Gallery, Projects and General > How do I??

Roll pin removal

<< < (4/5) > >>

John Rudd:
Ok,
The Ezi Out option is a non starter, my smallest won't grip the inside of the pin....

I also tried gripping in the chuck (3 jaw ) and striking with a hammer ( shaft end ) but it's not budging...


Heat is the next option.....( hot air gun )......

awemawson:
You better start saving up postage stamps for a two way journey  :lol:

DavidA:
John,

Maybe you can drill right through the hole in the roll pin using a small drill,  then turn the thing over and drill at the pin diameter back toward the pin and then punch it out via the new hole.

Dave.

John Rudd:

--- Quote from: awemawson on July 22, 2015, 02:10:23 PM ---You better start saving up postage stamps for a two way journey  :lol:

--- End quote ---

No need it's out....apart,in bits  :dremel:.....yippeeeee

I put it back on the press, low and behold it popped out....

So the pin  just stops the post bolt from turning....simple but effective..

So, now I need to get on with making a new one for my ( yet to buy) qctp....

Thanks for your help guys....much appreciated... :D :clap:

appletree:
That old saying “where there’s a will there’s a way"

Navigation

[0] Message Index

[#] Next page

[*] Previous page