| Gallery, Projects and General > How do I?? |
| Roll pin removal |
| << < (4/5) > >> |
| John Rudd:
Ok, The Ezi Out option is a non starter, my smallest won't grip the inside of the pin.... I also tried gripping in the chuck (3 jaw ) and striking with a hammer ( shaft end ) but it's not budging... Heat is the next option.....( hot air gun )...... |
| awemawson:
You better start saving up postage stamps for a two way journey :lol: |
| DavidA:
John, Maybe you can drill right through the hole in the roll pin using a small drill, then turn the thing over and drill at the pin diameter back toward the pin and then punch it out via the new hole. Dave. |
| John Rudd:
--- Quote from: awemawson on July 22, 2015, 02:10:23 PM ---You better start saving up postage stamps for a two way journey :lol: --- End quote --- No need it's out....apart,in bits :dremel:.....yippeeeee I put it back on the press, low and behold it popped out.... So the pin just stops the post bolt from turning....simple but effective.. So, now I need to get on with making a new one for my ( yet to buy) qctp.... Thanks for your help guys....much appreciated... :D :clap: |
| appletree:
That old saying “where there’s a will there’s a way" |
| Navigation |
| Message Index |
| Next page |
| Previous page |