| Gallery, Projects and General > How do I?? |
| need to move a lathe |
| << < (4/9) > >> |
| shipto:
--- Quote from: shipto on July 14, 2015, 12:26:58 PM ---I have the chance of Harrison 14" lathe like http://www.lathes.co.uk/harrison/page9.htmlthis one. Does anyone have any experience of moving anything like it? how much can it be split apart? --- End quote --- Scratch that I was going on my uncle telling me it is a harrison 14 however it isnt. I looked at it today and to me it looks more like a early L5, or at least thats the closest I can match it from the lathes website. The one thing I cant find however is a model with the oil level pot (or at least thats what I think it is) like this one. I have a picture in all its rusted glory with the oil pot marked. Dont judge too harshly my uncle is 89 and probably hasnt even turned it on for years but I do have a lot of cleaning up to do. |
| mexican jon:
The other thing that is curious is the position of the saddle traverse hand wheel :scratch: early Harrison lathes had the hand wheel at the chuck end of the saddle not the back :scratch: |
| shipto:
Good point I didnt notice that until you mentioned it. |
| mexican jon:
Another thing that is bugging me is :scratch: the stand under the chuck end is very much like a Colchester as is the saddle and the cross slide :loco: the Early Colchester lathes had the hand wheel at the rear :hammer: I wonder if you have got a cross bred or a special :Doh: I'll be very interested to find out what it is when you eventually identify it :drool: |
| RussellT:
Is that a little surface grinder or a horizontal mill in the background? Is that included too. Russell |
| Navigation |
| Message Index |
| Next page |
| Previous page |